Skip to content
RigPrints

Gaps

Wanted

Parts with no model in this library yet. These are the ones that show up on the bench and still send you to a dealer. If you drew one, send the link.

10 open requests

  • Norcold

    Norcold 1210 upper door hinge bushing

    1210 / 1211 series, the nylon bushing in the upper hinge

    The library has lower hinges and latches for other Norcold boxes. This bushing is the piece that ovalizes and lets the door sag.

    No model yet

  • Lippert

    Lippert Schwintek in-wall switch bezel

    In-wall slide switch surround, not the controller or the bearing block

    Bearing blocks show up. The thin bezel around the wall switch cracks and is rarely modeled on its own.

    No model yet

  • MaxxAir

    MaxxAir MaxxFan Deluxe lid strut clip

    Deluxe / Plus lid, the clip that keeps the cover from slamming

    Knobs and a Sprinter adapter are in the library. The lid strut clip is still a dealer part.

    No model yet

  • Fantastic Fan

    Fantastic Fan crank arm, pre-2010 lid

    Older manual lift, the crank arm rather than the knob

    Lift brackets and locking knobs exist. The bent crank that actually raises the older lid does not.

    No model yet

  • Dometic

    Dometic RM-series freezer door bin

    RM7401 / RM7405 style door bin, the molded shelf that snaps off

    Latches, knobs, and vent clips are covered. The door bin itself is still missing.

    No model yet

  • Thetford

    Thetford C260 pour-out spout cap

    C250 / C260 cassette, the cap on the pour-out spout

    Handles, blades, and saddle ratchets are modeled. The spout cap is a small lost part with no file yet.

    No model yet

  • Fiamma

    Fiamma F65 lead-bar end plug

    F65 / F65S awning, plastic plug at the end of the lead bar

    A few Fiamma caps and rafter repairs are listed. This end plug is not among them.

    No model yet

  • Truma

    Truma Combi control knob insert

    Combi heater panel, the insert under the control knob

    Truma shows up as trim. The knob insert that splits on the control panel does not.

    No model yet

  • Winnebago

    Winnebago entry-door striker plate

    Entrance door grabber latch, the striker the latch closes on

    Cabinet latches and Revel hardware are here. The entrance striker is a wear item without a model.

    No model yet

  • Suburban

    Suburban water-heater door latch

    SW6DE / SW6D style exterior door, the turn latch

    High-heat appliance doors are a gap on purpose. Measure twice, and do not print a latch that has to hold a hot door shut unless you know the material.

    No model yet

Request

Ask for a part

Name the piece, the brand, and a part number if you have one. A photo link helps. If someone has already published a model, use Submit a part instead.

Posts to Formspree. We only use the address to follow up on the part.